lab extruder

The Lab Single Screw Extruder is used for demonstrating & testing the properties of pigments, master batches & compounds.
The lab Single Screw Extruder allows running small test batches prior to production.
The sample material is plasticized and extruded through Die head. All measuring values such as torque, melt pressure, melt temperature are recorded continuously and represented in the form of tables and graphs parallel to running test.

Screw &Barrel in High –Grade nitride Steel, Screw Diameter 20 ,25 & 30 mm , all with L/D ratio of different application.
AC Motor Drive, Coupled directory to a in line Helical Gear Box for Minimum Loss Factor and Maximum Life Time.
Digital Programmable set and readout Temperature Controllers for all zone coupled to Solid – State relays for accurate heat Control. The Controllers are Selt – Tuning and Equipped with Programmed auto compensation ensure a precise temperature over the entrier working range of 0 to 300 °C .
Extruder Supplied with Downstream Water Bath and Pelletizer are equipped with Chromed Strand Die head with one, two respectively four Strands for 20, 25, & 30 MM Extruders also Blown Film attachment with Die Head, Air Ring, Take off Tower and Single Station centre winder.
The Die is Complete with Electrical Band Heater and Digital Programmable and Self –turning Controller.
Single Screw Extruder incorporate with Data Acquisition PLC System.

Extruder Model	Straight Compression Ratio	Screw Diameter	Screw L/D Ratio	Throughputwith Polymer Kg/Hr.	Motor HM(KW)	Screw Speed Range RPM	No. of Heat Zone on Barrel
DSSE – 20	1:3	20	24/26/28	6 - 10	1.5	0-150	3
DSSE – 25	1:3	25	24/26/28	12 - 18	4	0-300	4
DSSE - 30	1:3	30	24/26/28	25 - 30	7.5	0-250	4